Skip to main content

SZL Series Boiler Performance Characteristics

 SZL series boiler adopts quick installation water pipe structure, which is fully assembled in the factory before leaving the factory. It consists of two parts, the upper part is the body heating surface, and the lower part is the combustion equipment. Around the front end of the boiler body for arrangement of water-cooled wall connected to the drum bottom connected to the header of the combustion chamber, to absorb the furnace radiant heat, backend arrangement between water drum on intensive convection tube bundle, high temperature flue gas after combustion after secondary return lateral erosion convection heating surface to separate arrangement of economizer, finally into dust catcher by chimneys; The water-tube boiler assembled above 20t/h is composed of front furnace, rear furnace, convection tube bundle, economizer and chain grate, which are assembled into an integral factory.


SZL Series Boiler Performance Characteristics

  1. The boiler absorbs the advantages of quick installation: the upper large part is composed of the boiler body, the upper furnace wall and insulation layer, and the lower large part is composed of chain grate and coal hopper, which is easy to install, short cycle and less cost.
  2. The boiler has compact structure, small floor area, beautiful appearance and generous appearance. The boiler room only needs a single layer layout and less investment in infrastructure project.
  3. The boiler is easy to operate, stable in operation, fast in heating and pressure increasing, full in output, suitable for a wide range of coal.
  4. Complete auxiliary equipment, drum, induced draft fan, water pump, dust collector and so on can meet the boiler load requirements, wide speed range.
  5. The boiler equipped with relatively complete thermal instrumentation, electronic control board, drum, induced draft fan open, grate speed can achieve automatic operation, the boiler water temperature has overtemperature protection device, when the water temperature rise in excess of the prescribed or automatically when the circulating water pump suddenly stopped cutting drum, induced draft fan and stop grate, boiler is equipped with the overpressure alarm and water level automatic control device.
  6. Boiler air supply adopts two sides of silo type air supply device, each air chamber can be independently adjusted, small air leakage, strong adjustable, can better adapt to the chain grate combustion characteristics of the requirements.

This series of industrial boilers absorb the advantages of quick installation boilers, and have the advantages of compact structure, single layer layout of boiler room, convenient site installation, short cycle time, low cost and simple operation. This series of steam boilers are suitable for industrial and domestic steam, and hot water boilers of corresponding capacity are suitable for industrial and civil heating. Welcome everybody to come to consult purchasing Zozen Boilers.

E-mail us: sunhui@zozen.com




Comments

Post a Comment

Popular posts from this blog

Parameters and technical requirements of 6-ton gas-fired steam boiler for hospital use

 The 6ton gas-fired steam boiler is commonly used in hospitals, and its process requirements are as follows: Natural gas boiler: natural gas → burner → boiler → steam → sub-cylinder → steam point. Tap water constant pressure water supply → water softener → soft water insulation water tank → energy saver → boiler. Hospitals are densely populated places, so the requirements for boiler equipment and suppliers are relatively strict. Suppliers of 6ton gas boilers must have a Class A boiler manufacturing license, a pressure vessel manufacturing license, a Class 2 boiler installation, renovation and maintenance license or above. The equipment supplier shall be responsible for obtaining relevant certificates and fees such as the registration certificate for installation and use of boiler equipment. The water supply of this series of gas boilers is designed with a flue gas condensation recovery device to recover the heat energy of the flue gas, and the exhaust gas temperature is less than...
Post a Comment
Read more

SZS Gas-Fired Horizontal Water-Tube Saturated Steam Boiler

 The pipelines within the scope of the SZS watertube steam boiler only include the valves and pipelines from the flange of the return water check valve to the outlet valve and drain valve of the boiler body. Accessories include valves and gauges for the boiler body. Such as pressure gauges, air valves, spring safety valves, outlet and return valves, check valves, thermometers, etc. The SZS gas-fired steam boiler is equipped with a flue gas condenser at the tail of the boiler body, which reduces the flue gas temperature (<70°C), improves the boiler efficiency and reduces the harmful components in the flue gas. The boiler adopts micro-positive pressure combustion, and the furnace wall tube is a full-membrane wall structure. This series of boiler products has a certain pressure bearing capacity, and no smoke leakage and air leakage will occur when running under a slightly positive pressure state. The boiler is a self-contained boiler, which can shorten the installation period whi...
Post a Comment
Read more

35 Tons SZS Gas Steam Boiler

 The SZS gas fired steam boiler is equipped with a flue gas condenser at the tail of the boiler body, which reduces the temperature of the flue gas, improves the efficiency of the boiler, and reduces the harmful components in the flue gas. The szs gas boiler adopts micro-positive pressure combustion, and the furnace wall tube is a full-membrane wall structure. The 35ton gas-fired boiler has a certain pressure-bearing capacity, and there will be no smoke leakage and air leakage when running under a slightly positive pressure state. The boiler is a self-contained boiler, which can shorten the installation period while meeting the transportation size requirements. At the same time, the aluminum casing and the skeleton are transported and connected by bolts, which are convenient for disassembly and maintenance. The furnace of this series of boiler products adopts a model water-cooled wall structure, and the whole boiler adopts an air-tight inner shield with a fully enclosed welding s...
Post a Comment
Read more